Cisco Catalyst Devices- Syslog Support

Homepage http://www.cisco.com
Specifics
  • Make sure logging is enabled by using the set logging server enable command.
  • Specify the syslog server that is to receive the router syslog messages, using the logging <server_ip> command, where <server_ip> is the IP address of the SYSLOG server. set logging server 1.1.1.1
  • Enter set logging level informational, where informational signifies severity level 6. This means that all messages from level 0-5 (from emergencies to notifications) will be logged to the Syslog server. Command: set logging server informational
  • To see if syslog messages are being sent, use the sh logging buffer command.

If you are looking for more details please visit the followling link for the tutorial on Cisco's website.


Still problems enabling syslog? Find the solution in our forum or post a question there!

Syslog messages generated by these products can be received by MonitorWare Agent and WinSyslog.

All information in this section is to the best of our knowledge but without warrenty of any kind. This is free information - use it at your sole risk.

[Back to Syslog Enabled Products]


 

Back to Non-Printer Version