NetScreen Firewalls - Syslog Support
Please Note: NetScreen has been bought by Juniper Networks. All Support and technical documentation is now available at their website.
NetScreen supports syslog and has many options to configure it. Basically, syslog
is enabled via the administrative GUI via the following steps:
- click on "admin" in the configuration GUI
- select the "syslog" tab
- set the IP address of the system where the syslog service is running
- if you have changed the syslog listener port, adjust it, too
- apply these changes and you are done
For more information please see NetScreen's manuals available at
http://www.juniper.net/techpubs/ under NetScreen Products.
Still problems enabling syslog? Find the solution in our
forum or post a question there!
Syslog messages generated by these products can be received
by MonitorWare Agent and
All information in this section is to the best of our knowledge but without warrenty of
any kind. This is free information - use it at your sole risk.
[Back to Syslog Enabled