3COM Super Stack 2 Switch 3800 - Syslog Support
| Homepage |
www.3com.com |
| Specifics |
Use the following command to enable logging to a remote syslog host:
enable syslog
The config syslog command is also useful:
config syslog <ip_address> <facility> {<priority>} {<subsystem>}
It allows you to configure the syslog host address and filter messages sent to the syslog host. Options include:
- ipaddress - The IP address of the syslog host.
- facility - The syslog facility level for local use. priority - Filters the log to display message
with the selected priority or higher (more critical). Priorities include critical, warning, and informational.
If not specified, only critical priority messages and are sent to the syslog host.
- subsystem - Filters the log to display messages associated with the selected Switch subsystem.
Subsystems include Syst, STP, Brdg, SNMP, Telnet, VLAN, and Port.
If not specified, all subsystems are sent to the syslog host.
For more information, please also have a look at the configuration page for the
3com Super Stack II Switch 9100.
|
Still problems enabling syslog? Find the solution in our
forum or post a question there!
Syslog messages generated by these products can be received
by MonitorWare Agent and
WinSyslog.
All information in this section is to the best of our knowledge but without warrenty of
any kind. This is free information - use it at your sole risk.
[Back to Syslog Enabled
Products]
|
